| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
NOTE #2: the PARKING LIGHTS require an extra Relay part #775 and a (-)Negative thru a 110
Ohm Resistor, See DIAGRAM.
NOTE #3: the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to
LOCK and a (+)Positive thru a 620 Ohm resistor to UNLOCK, some units will also
require 2 extra relays Part #775 for the keyless entry feature to function, See
DIAGRAMS. You can also get a INTERFACE BYPASS MODULE the Part XK09 that will
do this for you without adding extra relays and resistors, these Modules will also do
dome light supervision and trunk pop with nothing needed, to order please go to
the INTERFACE BYPASS MODULE Page on this website
NOTE #4: This vehicle uses a Multi-Coil system, for TACH use any wire at the coil pack that has
a TAN STRIPE wire.
NOTE #5: you must use both the TAN(-) and the TAN/RED (-) wires when connecting to an
ALARM SYSTEM and DIODE ISOLATE, See DIAGRAM
NOTE #6: the BCM (Body Control Module) is located on the LEFT SIDE of the DASH attached to
the Junction block.
NOTE #7: the DISARM wire requires an extra relay part #775 and a (+)Positive thru a 680 Ohm
Resistor, to connect, See DIAGRAM