NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: the PARKING LIGHTS require a (-)Negative thru a 110 Ohm Resistor and an extra
Relay Part #775, to connect, See DIAGRAM.
NOTE #3: this vehicle uses a 1-Wire Door Locking System, LOCK requires a (+)Positive thru
a 2700 Ohm Resistor and UNLOCK requires a (+)Positive thru a 620 Ohm Resistor,
some units will also require 2 extra relays part #775, to connect, See DIAGRAM
NOTE #4: when connecting to an ALARM SYSTEM, use BOTH DOOR TRIGGER wires and
DIODE ISOLATE, to connect, See DIAGRAM
NOTE #5: the BCM (Body Control Module) is located on the DRIVERS SIDE of the DASH
attached to the FUSE/JUNCTION block.
NOTE #6; this FACTORY DISARM wire will require extra parts: the 1998 ONLY, will require the
relay Part #775 and not a resistor. On 1999 and up, they will require a relay
Part #775 and a (-)Negative thru a 680 Ohm Resistor, to connect, See DIAGRAM
|