PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE/WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 2	DARK GREEN/RED (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	YELLOW (-) See NOTE *1	@ HEADLIGHT SWITCH, See DIAGRAM
PARKING LIGHTS ( + )	DO NOT USE!
POWER LOCK	WHITE/GREEN (1-Wire Door Lock System) See NOTE *2	@ BACK of FUSE PANEL, See DAIGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	TAN (-) and TAN/RED (-) Use both, See NOTE *3	@ BCM, See NOTE *4
DOMELIGHT SUPERVISION	YELLOW (-), Requires #R30-H Relay	@ FRONT of FUSEBOX, WHITE 3-Pin Plug
TRUNK RELEASE	BLACK/WHITE (+), Requires #R30-H Relay	@ TRUNK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
TACH	ANY TAN STRIPE wire	@ COIL PACK
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (-) See NOTE *5	IN DRIVERS DOOR HARNESS
ANTI-THEFT	CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS require a (-)Negative thru a 110 Ohm Resistor and an extra Relay Part #R30-H, to connect, See DIAGRAM. NOTE *2 this vehicle uses a 1-Wire Door Locking System, LOCK requires a (+)Positive thru a 2700 Ohm Resistor and UNLOCK requires a (+)Positive thru a 620 Ohm Resistor, some units will also require 2extra relays part #R30-H, to connect, See DIAGRAM NOTE *3 when connecting to an ALARM SYSTEM, use BOTH DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *4 the BCM (Body Control Module) is located on the DRIVERS SIDE of the DASH attached to the FUSE/JUNCTION block. NOTE *5 this FACTORY DISARM wire will require extra parts: the 1998 ONLY, will require the relay Part #R30-H and not a resistor. On 1999 and up, they will require a relay Part #R30-H and a (-)Negative thru a 680 Ohm Resistor, to connect, See DIAGRAM