PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE/WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 2	GREEN/RED (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	YELLOW (-) See NOTE *1	@ HEADLIGHT SWITCH, See DIAGRAM
PARKING LIGHTS ( + )	DO NOT USE!
POWER LOCK	WHITE/GREEN (1-Wire Door Lock System) See NOTE *2	@ BACK of FUSEBOX, See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS
DOOR TRIGGER	TAN (-) and TAN/RED (-) Use both, See NOTE *4	@ BCM, See NOTE *5
DOMELIGHT SUPERVISION	YELLOW (-), Requires #R30-H Relay	@ REAR of FUSEBOX, BROWN Plug
TRUNK RELEASE	BLACK/WHITE (+), Requires #R30-H Relay	@ TRUNK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
TACH	See NOTE *3	@ IGNITION COIL PACK
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (+) See NOTE *6	IN DRIVERS KICK PANEL
ANTI-THEFT	CHRYSLERS SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 the PARKING LIGHTS require an extra Relay part #R30-H and a (-)Negative thru a 110 Ohm Resistor, See DIAGRAM. NOTE *2 the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to LOCK and a (+)Positive thru a 620 Ohm resistor to UNLOCK, some units will also require 2 extra relays Part #R30-H for the keyless entry feature to function, See DIAGRAMS. NOTE *3 This vehicle uses a Multi-Coil system, for TACH use any wire at the coil pack that has a TAN STRIPE wire. NOTE *4 you must use both the TAN(-) and the TAN/RED (-) wires when connecting to an ALARM SYSTEM and DIODE ISOLATE, See DIAGRAM NOTE *5 the BCM (Body Control Module) is located on the LEFT SIDE of the DASH attached to the Junction block. NOTE *6 the DISARM wire requires an extra relay part #R30-H and a (+)Positive thru a 680 Ohm Resistor, to connect, See DIAGRAM