NOTE #1: the EEM (Electronic Entry Module) is located on the Drivers side of the transmission
tunnel.
NOTE #2: this is a 1-Wire door locking system, a pulse of (+) Positive voltage to this wire will
lock the doors another pulse of (+) Positive to the same wire will unlock the doors, if
you are using a unit without on board door lock relays, you will need to add relays to
operate the door locks.
NOTE #3: the drivers Door trigger is a BLACK/LIGHT BLUE (-) Pin C15, the Passenger door
trigger is a TAN/RED (-) Pin C16 both wires are located at the EEM. When connecting
to an ALARM SYSTEM,use both DOOR TRIGGER wires and DIODE ISOLATE. to connect,
See DIAGRAM
NOTE #4: the PCM (Powertrain Control Module) is located on the DRIVERS FENDER under the
POWER DISTRIBUTION CENTER .
|