NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: the PARKING LIGHTS require an extra relay Part #775 and a (-)Negative thru a 110
Ohm Resistor, to connect, See DIAGRAM
NOTE #3: the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to
LOCK and a (+)Positive thru a 620 Ohm resistor to UNLOCK, some units will also
require 2 extra relays for the keyless entry feature to work properly, See DIAGRAMS.
NOTE #4: The BCM (Body Control Module) is located under the DRIVERS SIDE DASH attached to
the JUNCTION BLOCK.
NOTE #5: This vehicle uses a Multi-Coil pack ingition system, the TACH wire will be any wire with
a TAN STRIPE at the coil pack. (AC)
NOTE #6: the DISARM wire requires an extra relay part #775 and a (+)Positive thru a 680 Ohm
Resistor, to connect, See DIAGRAM
NOTE #7: this vehicle uses 2 Door Trigger wires, when connecting to an ALARM SYSTEM, use
both wires and DIODE ISOLATE, See DIAGRAM
|