Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 1998 -2000 Toyota Rav4 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
PART
COLOR
LOCATION
12 VOLT
CONSTANT
WHITE (+)
@ FUSE BOX
STARTER
RED (+) (18 Gauge wire)
IGNITION SWITCH HARNESS
STARTER
2
N/A
IGNITION
1
BLACK/YELLOW (+) (18 Gauge wire)
IGNITION SWITCH HARNESS
IGNITION
2
BLACK/WHITE (+) (18 Gauge wire)
IGNITION SWITCH HARNESS
IGNITION
3
N/A
ACCESSORY/HEATER
BLOWER 1
BLUE/RED (+) (18 Gauge wire)
IGNITION SWITCH HARNESS
ACCESSORY/HEATER
BLOWER 2
N/A
KEYSENSE
N/A
PARKING
LIGHTS ( - )
LIGHT GREEN (-)
@ STEERING COLUMN HARNESS
PARKING
LIGHTS ( + )
GREEN (+)
@ 15-PIN WHITE PLUG, LEFT of the STEERING COLUMN
POWER LOCK
BLUE/WHITE (Negative (-))
@ INTEGRATION RELAY, See NOTE *1
POWER UNLOCK
BLUE/YELLOW (Negative (-))
@ INTEGRATION RELAY, See NOTE *1
DOOR TRIGGER
RED/YELLOW (-) and/or RED/WHITE (-)
See NOTE *2
DOMELIGHT
SUPERVISION
RED/YELLOW (-), Requires Part #R30-H Relay
@ BOTTOM of JUNCTION BOX
TRUNK RELEASE
N/A
SLIDING
POWER DOOR
N/A
HORN
GREEN/RED (-)
@ STEERING COLUMN HARNESS
TACH
BLACK
@ IGNITION COIL, WHITE PLUG
WAIT TO
START LIGHT
N/A
BRAKE
GREEN/WHITE (+)
@ SWITCH ABOVE BRAKE PEDAL
FACTORY
ALARM DISARM
N/A
ANTI-THEFT
N/A
EXTRA
INFORMATION
NOTE *1 the INTEGRATION RELAY, is located UNDER the DRIVERS SIDE of the DASH.
NOTE *2 the RED/WHITE (-) is for the REAR doors on the 4-DOOR Models, this wire also catches the REAR Hatch. Wires are located at the BOTTOM of the JUNCTION BOX
