PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	PURPLE (+) or YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	WHITE (+) See NOTE *4	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT SWITCH or in DRIVERS KICK PANEL
POWER LOCK	LIGHT BLUE (TYPE A)	IN EITHER DOOR HARNESS
POWER UNLOCK	WHITE (TYPE A)	IN EITHER DOOR HARNESS
DOOR TRIGGER	PURPLE (-)	@ HEADLIGHT SWITCH
DOMELIGHT SUPERVISION	WHITE (-), Requires #775 Relay	@ UNDER DASH LIGHT
TRUNK RELEASE	BLACK (+) or BLACK/WHITE (+) See NOTE *2, Requires #775 Relay	LOW in DRIVERS KICK PANEL
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ STEERING COLUMN HARNESS
TACH	WHITE	@ ECM, See NOTE *1
WAIT TO START LIGHT	See NOTE *3
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	YELLOW (+), ORANGE/BLACK (-) and RED/WHITE (Not used)	GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column.

EXTRA INFORMATION

NOTE *1 The ECM (Electronic Control Module) is located on the DRIVERS SIDE INNER FENDER. TACH wire is in BLACK plug marked "WHITE" NOTE *2 If vehicle has REAR LIFT WINDOW it is a (+)Positive wire, if it has a CARGO DOOR it is a Reverse-polarity wire. See DIAGRAM NOTE *3 when hooking up a REMOTE STARTER on a DIESEL, you will need to program in the 5,10 or 15 Second WAIT to START TIMMER in the Installation Manual. On some vehicles the Wait to Start Light on the dash is not a true (+)Positive or (-)Negative and the wire from the Remote Starter will not work. NOTE *4 IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!!