PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	RED/BLACK (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLUE (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	YELLOW/BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	If Equipped with DRL See NOTE *2	@ HEADLIGHT SWITCH See DIAGRAM
PARKING LIGHTS ( + )	NOT equipped with DRL See NOTE *2	@ HEADLIGHT SWITCH See DIAGRAM
POWER LOCK	GREEN/BLUE (Negative (-)) See NOTE *4	@ KEYLESS ENTRY MODULE, C3 Pin 12 See NOTE * 3
POWER UNLOCK	BROWN/YELLOW or BROWN/GRAY (Negative (-)) Requires Double Pulse	@ KEYLESS ENTRY MODULE, C3 Pin 6 See NOTE *3
DOOR TRIGGER	See NOTE *5	@ KEYLESS ENTRY MODULE See NOTE *3
DOMELIGHT SUPERVISION	TURNS ON with UNLOCK
TRUNK RELEASE	PURPLE/GREEN (+)	@ HATCH RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK/YELLOW (-)	@ HORN RELAY, UNDER DRIVERS SIDE of DASH
TACH	N/A
WAIT TO START LIGHT	N/A
BRAKE	RED/BLACK (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS WITH UNLOCK, Single Pulse on UNLOCK wire, Disarms
ANTI-THEFT	N/A

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 On vehicles with DLR, use the GRAY/GREEN (+) at the HEADLIGHT SWITCH, use a RELAY to isolate this wire use the DIAGRAM 5-WIRE ISOLATION on the (-) PARKING LIGHTS INFO. On vehicles without the DRL, use the GREEN/BLACK (+) and GREEN/RED (+) wires at the HEADLIGHT SWITCH and use the DIAGRAM DAUL PARKING LIGHT NOTE *3 the FACTORY KEYLESS ENTRY MODULE is located under the DRIVERS side floor mat in front of the DRIVERS SEAT. NOTE *4 IGNITION CONTROLLED DOOR LOCK will cause problems with the door locks DO NOT USE!!! NOTE *5 DRIVERS DOOR TRIGGER IS GREENYELLOW (-) IN CONNECTOR 5 PIN 1, FRONT PASSANGER DOOR IS RED/GRAY (-) IN C5, PIN10 LEFT REAR DOOR IS BLACK/RED (-) IN C5 PIN 12 ,AND RIGHT REAR DOOR IS BLACK/PURPLE (-) IN C5 PIN 14 WHEN CONNECTING TO AN ALARM SYSTEM USE ALL 4 WIRES AND DIODE ISOLATE SEE DIAGRAM