PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) and RED/WHITE (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	WHITE (+) See NOTE *5	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT SWITCH
POWER LOCK	LIGHT BLUE (TYPE B)	IN EITHER KICK PANEL
POWER UNLOCK	WHITE (TYPE B)	IN EITHER KICK PANEL
DOOR TRIGGER	See NOTE *2	@ BCM, See NOTE *1
DOMELIGHT SUPERVISION	TAN (-)	@ BCM, See NOTE *1
TRUNK RELEASE	N/A
SLIDING POWER DOOR	LIGHT BLUE (-) See NOTE *3	IN PASSNEGERS KICK PANEL
HORN	BLACK (-)	@ STEERING COLUMN HARNESS
TACH	PURPLE/WHITE or WHITE	See NOTE *4
WAIT TO START LIGHT
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	ORANGE/BLACK (-)	IN EITHER KICK PANEL
ANTI-THEFT	GM's PASSKEY 3 (PK3 on Steel Shaft of Ignition Key) TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 The BCM (Body Control Module) is located ABOVE the PASSENGER SIDE KICK PANEL. NOTE *2 This vehicle has (3) door trigger wires. The DRIVERS DOOR is a TAN (-), PASSENGER DOOR and LIFT GATE is a DARK BLUE (-) and ORANGE (-) for the SLIDING DOOR(S). When connecting to an ALARM SYSTEM use all 3 wires and DIODE ISOLATE. See DIAGRAM NOTE *3 A pulse of (-)Negative to this LIGHT BLUE (-) wire will OPEN the power sliding door and a pulse of (-)Negative on the same wire will then CLOSE the power sliding door. This wire is in a large BLACK connector just below the BCM. NOTE *4 The TACH wire is in the MAIN HARNESS on the DRIVERS SIDE of the ENGINE, ON TOP of the Manifold Cover. NOTE *5 IMPORTANT !!!!! this wire MUST BE CONNECTED for REMOTE STARTING!!!!!!