Vehicle Wiring Details for a
1997 Lincoln Continental
Item Wire Color Polarity Wire Location
12V wht/yel or blk/orn Positive (+) ignition harness
Starter red/lt. blue Positive (+) ignition harness
Starter 2 none
Ignition brown/pink Positive (+) ignition harness
2nd Ignition none
3rd Ignition none
Accessory gray/yellow (2) Positive (+) ignition harness
Accessory 2 black/lt. green Positive (+) ignition harness
Tachometer pink/white ignition coil
Power Door (Lock)
Wiring Diagram for
[Positive (+)] Door Lock
pink/yellow Positive (+) drivers door harness
Power Door (Unlock)
Wiring Diagram for
[Positive (+)] Door Unlock
pink/green Positive (+) drivers door harness
Door Trigger blue and blk/orn Negative (-) [2]
Dome Supervision
Wiring Diagram for
[Positive (+)] Dome
black/lt. blue Positive (+) LCM [1]
Headlights blu/wht & grn/orn Positive (+) LCM [1]
Parklight Positive white Positive (+) drivers kick
Parklight Negative none
Wipers blu/orn & white Negative (-) WCM [3]
Left Front Window
red/yel - yel/red drivers door switch
Right Front Window
yellow - wht/blk RF window switch
Left Rear Window
brn/yel - brown A LR window switch
Right Rear Window
brn/yel - brown A RR window switch
Trunk/Hatch Pin brown/white Negative (-) LCM [1]
Hood Pin yellow/red Negative (-) LCM [1]
Trunk/Hatch Release
Wiring Diagram for
[Negative (-)] Trunk/Hatch
orange/lt. green Negative (-) LCM [1]
Factory Alarm
Factory Alarm
dk. green/purple Negative (-) LCM [1]
Horn blue Negative (-) LCM [1]
Brake lt. green Positive (+) LCM [1]
Door Motor
pink/black drivers door harness
Door Motor
red/orange in drivers door
Disarm pink/orange drivers door harness
Disarm No Unlock none
Additional Info:
[1] The LCM (Lighting Control Module) is attached to the headlight switch. [2] The blue wire catches the drivers door, it is in the drivers door harness. The black/orange wire catches all the other doors, it is at the LCM. Use both wires and diode isolate each. [3] The WCM (Wiper Control Module) is located next to the LCM. The fuel door can be opened with a postive trigger to white/pink located in the drivers door harness.

ATTENTION: This wiring information is being provided free of charge and on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it by using a digital multimeter. GNU Industries, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. GNU assumes no responsibility resulting from an improper installation, even in reliance upon this information.

Copyright © 2000-2006 GNU Industries, Inc. All Rights Reserved.