| Item |
Wire Color |
Polarity |
Wire
Location |
| 12V |
pink/black,red (20A) |
Positive (+) |
ignition harness |
| Starter |
yellow/gold dots |
Positive (+) |
ignition harness |
| Starter 2 |
none |
|
|
| Ignition |
dk. blue/gold dots |
Positive (+) |
ignition harness |
| 2nd Ignition |
red/wht/gold dots |
Positive (+) |
ignition harness |
| 3rd Ignition |
none |
|
|
| Accessory |
black/orange |
Positive (+) |
ignition harness |
| Accessory
2 |
none |
|
|
| Tachometer |
red,white,black |
|
at coil pack [1] |
Power Door
(Lock)
Wiring
Diagram for
[Positive (+)]
Door Lock |
orange/white [2] |
Positive (+) |
white plug at back of |
Power Door (Unlock)
Wiring
Diagram for
[Positive (+)]
Door Unlock |
pink/purple [2] |
Positive (+) |
dash fuse/relay panel |
| Door Trigger |
tan and tan/red |
Negative (-) |
driver kick panel[4] |
Dome Supervision
Wiring
Diagram for
[none]
Dome |
none |
none |
none |
| Headlights |
green |
Positive (+) |
headlight switch |
| Parklight Positive |
black/yellow |
Positive (+) |
driver's kick panel |
| Parklight Negative |
|
|
|
| Wipers |
pink |
Positive (+) |
[3] see notes |
Left Front Window
(Up/Down) |
lt.blu/gld - wht/gld |
|
in drivers door |
Right Front Window
(Up/Down) |
brn/wht - pur/wht |
|
in drivers door or dkp |
Left Rear Window
(Up/Down) |
blu/wht - red/blk |
A |
in drivers door or dkp |
Right Rear Window
(Up/Down) |
gry/blk - grn/wht |
A |
in drivers door or dkp |
| Trunk/Hatch Pin |
brown/black |
Negative (-) |
driver's kick panel |
| Hood Pin |
|
|
|
Trunk/Hatch Release
Wiring
Diagram for
[Positive (+)]
Trunk/Hatch |
black/white |
Positive (+) |
at switch |
Factory Alarm
(Arm) |
lock |
|
|
Factory Alarm
(Disarm) |
lt.green/orange 20ga |
Negative (-) |
either kick |
| Horn |
black/red |
Negative (-) |
relay in fuse block |
| Brake |
white |
Positive (+) |
at brake switch |
Door Motor
(Lock) |
none |
none |
none |
Door Motor
(Unlock) |
none |
none |
none |
| Disarm |
none |
none |
none |
| Disarm No Unlock |
none |
none |
none |
 |
| Additional
Info: |
| The SRS (air bag) warning light may come on after remote started, after the key is inserted and the remote start shut down with the brake. IfThis happens, find an 18ga (NOT 12ga) red/white in the ignition harness. Power it as an Ign 3 with an additional relay. [1] Most Chrysler V6 engines use triple coil pack. Use one of these wires and set unit to the two(2) cylinder setting [2] Also find same colors in harness to right of glove box by passenger kick panel. [3] Three-wire connector, heavy gauge, near wiper motor. [4] Tan gets drivers door, tan/red gets pass. doors. Tap both wires and diode isolate. |
|
|
|
ATTENTION:
This wiring information is being provided free of charge and on
an "as is" basis, without any representation or
warranty. It is your responsibility to verify any circuit before
interfacing with it by using a digital multimeter. GNU Industries,
Inc. assumes no responsibility with regards to the accuracy or currency
of this information. Proper installation in every case is and remains
the responsibility of the installer. GNU assumes no responsibility
resulting from an improper installation, even in reliance upon this
information.
Copyright ©
2000-2006 GNU Industries, Inc. All Rights Reserved. |
|