Vehicle Wiring Details for a
1997 BMW Z3
Item Wire Color Polarity Wire Location
12V red Positive (+) ignition harness
Starter black/yellow Positive (+) ignition harness
Starter 2 none
Ignition green Positive (+) ignition harness
2nd Ignition purple Positive (+) ignition harness
3rd Ignition none
Accessory
Accessory 2 none
Tachometer black [3]
Power Door (Lock)
Wiring Diagram for
[Positive (+)] Door Lock		 lt. green/white Positive (+) factory alarm plug[1]
Power Door (Unlock)
Wiring Diagram for
[Positive (+)] Door Unlock		 blue/red Positive (+) factory alarm plug[1]
Door Trigger brn/gry, brown/blue Negative (-) factory alarm plug[1]
Dome Supervision
Wiring Diagram for
[none] Dome		 none none none
Headlights
Parklight Positive gry/ppl, gray/yellow Positive (+) at light switch
Parklight Negative blue/green (hazards) Negative (-) factory alarm plug[1]
Wipers
Left Front Window
(Up/Down)
Right Front Window
(Up/Down)
Left Rear Window
(Up/Down)
Right Rear Window
(Up/Down)
Trunk/Hatch Pin brown/white Negative (-) factory alarm plug[1]
Hood Pin purple/green Negative (-) [2]
Trunk/Hatch Release
Wiring Diagram for
[] Trunk/Hatch
Factory Alarm
(Arm)
Factory Alarm
(Disarm)
Horn
Brake blue/red Positive (+) brake switch [4]
Door Motor
(Lock) 		none none none
Door Motor
(Unlock)		 none none none
Disarm none none none
Disarm No Unlock none none none
Additional Info:
This vehicle is equiped with the EWS II immobilizer system that need to be bypassed when adding a remote start. [1] 12-pin, black factory alarm plug located behind glove box. [2] Single pin plug next to the factory alarm plug. [3] The wire is at the diagnostic plug in the passenger side rear of the engine compartment or can also find it behind the instrument cluster. Do not unplug the instrument cluster with the ignition on or turn the ignition on with the plug disconnected. [4] Brake wire will only meter with the ignition on.

ATTENTION: This wiring information is being provided free of charge and on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it by using a digital multimeter. GNU Industries, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. GNU assumes no responsibility resulting from an improper installation, even in reliance upon this information.

Copyright © 2000-2006 GNU Industries, Inc. All Rights Reserved.
一般æ¥è®²ï¼Œå¥³äººè¿‡äº†å‘育期丰胸产å“，想è¦ä¸°èƒ¸å°±ä¼šæ¯”较困难，ä¸è¿‡ä¹Ÿä¸æ˜¯ä¸è¡Œèƒ½çš„粉嫩公主酒酿蛋，这个时候需è¦å€ŸåŠ©ä¸“业的丰胸产å“，而且是å¥åº·æœ‰æ•ˆçš„丰胸产å“丰胸食物。添加WeChat获å–å…费一对一丰胸指导丰胸效果ï¼