NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a
Bypass module 791,(use this module IF you have a extra ignition key to place inside
the 791 to remote start, if you do not have an extra key to use or wish not to have a
key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS
MODULE that does not require a key to be placed inside the bypass modlue, this is
Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS
MODULE PAGE on this website.
NOTE #2; the (+) PARKING LIGHT wire may also be found at the TRAILER CONNECTOR next
to the Diagnostic Connector under the dash.
NOTE #3: If vehicle is equipped with FACTORY KEYLESS ENTRY it is a TYPE "B" Door Locking
System, without FACTORY KEYLESS it is a TYPE "C". Use the DRIVERS SIDE Switch
as the Master Switch when testing.
NOTE #4: This vehicle has 2 door triggers, when connecting to an ALARM SYSTEM, use both
wires and DIODE ISOLATE, to connect, See DIAGRAM
NOTE #5: The PCM (Powertrain Control Module) is located on the Passenger side of the engine
compartment, to the passenger side of the battery, below the hood stay, it is in a
104-Pin connector Pin 48.
|