Vehicle
Wiring Details for your
2004-2007 Mercury Monterey Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2004-2007 Mercury Monterey . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED (+) and LIGHT GREEN/PURPLE (+) |
@ IGNITION SWITCH HARNESS |
STARTER |
DARK GREEN (+) |
@ IGNITION SWITCH HARNESS |
STARTER
2 |
N/A |
|
IGNITION
1 |
WHITE/YELLOW (+) |
@ IGNITION SWITCH HARNESS |
IGNITION
2 |
BLACK/LIGHT GREEN (+) |
@ IGNITION SWITCH HARNESS |
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
PURPLE/ORANGE (+) |
@ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
N/A |
|
PARKING
LIGHTS ( + ) |
See NOTE #2 |
See DIAGRAM |
POWER LOCK |
WHITE/PURPLE (TYPE B) |
@ SJB, BLACK 26 Pin Plug, Pin 3, See NOTE #3 |
POWER UNLOCK |
DARK BLUE/LIGHT GREEN (TYPE B) |
@ SJB, BLACK 26 Pin Plug, Pin 1, See NOTE #3 |
DOOR TRIGGER |
ORANGE/WHITE (-) |
@ SJB, GRAY 26 Pin Plug, Pin 21, See NOTE #3 |
DOMELIGHT
SUPERVISION |
USE DOOR TRIGGER, (Requires #775 relay) |
|
TRUNK RELEASE |
YELLOW (-) |
@ SJB, GRAY 26 Pin Plug, Pin 15, See NOTE #3 |
SLIDING
POWER DOOR |
WHITE/LIGHT GREEN (-) (Left Door) and GREEN/RED (-) (Right Door), See NOTE #4 |
@ SJB, GRAY 26 Pin Plug, Pins 16 and 14, See NOTE #3 |
HORN |
DARK BLUE (-) |
@ SJB, BLUE 52 Pin Plug, Pin 39, See NOTE #3 |
TACH |
Any wire that is NOT RED (AC) |
@ IGNITION COIL or FUEL INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
RED/LIGHT GREEN (+) |
@ SJB, BLACK 36 Pin Plug, Pin 5, See NOTE #3 |
FACTORY
ALARM DISARM |
LIGHT BLUE/BLACK (-) |
@ SJB, BLACK 26 Pin Plug, Pin 9, See NOTE #3 |
ANTI-THEFT |
FORD'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will
need a Bypass module 791, use this module IF you have a extra ignition key to
place inside the 791 to remote start, if you do not have an extra key to use or wish
not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE
BYPASS MODULE that does not require a key to be placed inside the bypass module,
this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE
BYPASS MODULE PAGE on this website.
NOTE #2; this vehicle will require an extra Relay or Relays (part #775) depending on the
type of Parking lights on the vehicle, these relays are required to operate the
Parking light function from the unit, to connect, See DIAGRAM.
NOTE #3; the SJB (Smart Junction Block) is part of the FUSEBOX located under the Drivers
Side of the Dash, the BLACK 36 pin plug, and the BLUE 52 pin plug are on the front
of the SJB, all other plugs are on the back of the Module.
NOTE #4; to operate the Sliding Door feature will require (2) extra relays Part #775,
(1) for each door function. To connect up these relays, See DIAGRAM
|
|
|
|
|