Vehicle Wiring Details for a
1996 Mercury Sable
Item Wire Color Polarity Wire Location
12V lt.grn/ppl or yellow Positive (+) ignition harness
Starter red/lt. blue Positive (+) ignition harness
Starter 2 none
Ignition red/lt. green Positive (+) ignition harness
2nd Ignition
3rd Ignition none
Accessory gry/yel & red/blk Positive (+) ignition harness
Accessory 2 black/lt green Positive (+) ignition harness
Tachometer yellow/white[4] at coil 2 cyl. setting
Power Door (Lock)
Wiring Diagram for
[Negative (-)] Door Lock
pink/yellow Negative (-) drivers kick panel
Power Door (Unlock)
Wiring Diagram for
[Negative (-)] Door Unlock
pink/green Negative (-) drivers kick panel
Door Trigger black/lt. blue Positive (+) under dash light[1]
Dome Supervision
Wiring Diagram for
[] Dome
none
Headlights red/yellow Positive (+) headlight switch
Parklight Positive brown Positive (+) switch or fuse box
Parklight Negative
Wipers wht , dk. blue/org Positive (+) wiper motor [5]
Left Front Window
(Up/Down)
blk/wht - tan/ltblue drivers door at switch
Right Front Window
(Up/Down)
wht/yel - tan/ltblue drivers kick panel
Left Rear Window
(Up/Down)
yel/ltblu-gray/org A drivers kick panel
Right Rear Window
(Up/Down)
yel/blk - red/blk A drivers kick panel
Trunk/Hatch Pin black/pink Negative (-) at trunk light
Hood Pin none
Trunk/Hatch Release
Wiring Diagram for
[[2]] Trunk/Hatch
pnk/yel or gry/red [2] at release switch
Factory Alarm
(Arm)
Factory Alarm
(Disarm)
pink/white Negative (-) drivers kick panel
Horn purple/orange Negative (-) [3]
Brake red/lt. Green Positive (+) Brake switch or DKP
Door Motor
(Lock)
pink/black drivers kick panel
Door Motor
(Unlock)
red/white drivers kick panel
Disarm pink/orange drivers kick panel
Disarm No Unlock none
Additional Info:
This vehicle is equipped with PATS (Passive Anti Theft System). Use Commando module TransMod to over-ride during remote start. [1] Also found lt. green/orange (-) at headlight switch. Black/orange at GEM (instrument fuse panel) will get all doors and hatch on wagon. Rests at ground through ignition, cut and diode isolate. [2] There are 2 wires at the switch. If the switch has a pink/yellow and a gray/red use the pink/yellow as a negative trigger. If the swich has a gray/red and a purple/yellow, use gray/red as a positive trigger. [3] Four pin plug to right of steering column. [4] Coil & Harness behind intake manifold at back of engine compartment. [5] Also found at the fuse/relay box under hood.

ATTENTION: This wiring information is being provided free of charge and on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it by using a digital multimeter. GNU Industries, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. GNU assumes no responsibility resulting from an improper installation, even in reliance upon this information.

Copyright © 2000-2006 GNU Industries, Inc. All Rights Reserved.

一般æ¥è®²ï¼Œå¥³äººè¿‡äº†å‘育期丰胸产å“,想è¦ä¸°èƒ¸å°±ä¼šæ¯”较困难,ä¸è¿‡ä¹Ÿä¸æ˜¯ä¸è¡Œèƒ½çš„粉嫩公主酒酿蛋,这个时候需è¦å€ŸåŠ©ä¸“ä¸šçš„ä¸°èƒ¸äº§å“,而且是å¥åº·æœ‰æ•ˆçš„丰胸产å“丰胸食物。添加WeChat获å–å…费一对一丰胸指导丰胸效果ï¼