PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	IN DRIVERS KICK PANEL
POWER LOCK	RED/BLACK (Negative (-))	@ BCM, See NOTE *2
POWER UNLOCK	TAN and GRAY/BLACK (5 Wire Reverse Polarity) Use both, See NOTE *1	@ BCM, See NOTE *2
DOOR TRIGGER	GRAY/BLACK (-) and BLACK/WHITE (-) Use both, See NOTE *3	@ BCM, See NOTE *2
DOMELIGHT SUPERVISION	GRAY/BLACK (-)	@ BCM, See NOTE *2
TRUNK RELEASE	BLACK/WHITE (+)	@ HATCH RELEASE RELAY, See NOTE *4
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ STEERING COLUMN HARNESS
TACH	WHITE or RED/BLACK	@ IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	LIGHT BLUE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DISARMS with FACTORY REMOTE ONLY
ANTI-THEFT	2 WHITE or 1 WHITE and 1 PURPLE, wires are in an ORANGE tube	GM's VATS System @ Ignition Switch Harness

EXTRA INFORMATION

NOTE *1 the TAN will UNLOCK the DRIVERS DOOR and the GRAY/BLACK will UNLOCK the PASSENGER DOORS, both must be wired as a 5 Wire Reverse Polarity with separate relays part #R30-H, to connect. See DIAGRAM NOTE *2 the BCM (Body Control Module) is located in the PASSENGER KICK PANEL NOTE *3 the GRAY/BLACK (-) is for the DRIVERS DOOR and the BLACK/WHITE (-) is for the PASSENGER DOOR, when connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *4 the HATCH RELEASE RELAY is located near the Passenger kick panel