PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BLACK/YELLOW (+)	IN DRIVERS KICK PANEL or BEHIND FUSE BOX
POWER LOCK	WHITE/GREEN (1-Wire Door Lock System) See NOTE *1	REAR of FUSE BOX, See DIAGRAM
POWER UNLOCK	Same wire, See DIAGRAM	See DAIGRAM
DOOR TRIGGER	YELLOW (-)	@ FRONT of FUSE BOX or in 3-Pin plug near door jam
DOMELIGHT SUPERVISION	USE DOOR TRIGGER, Requires Part #R30-H Relay
TRUNK RELEASE	BLACK/WHITE (+), Requires Part #R30-H Relay	IN DRIVERS KICK PANEL
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
TACH	BLACK/GRAY	@ COIL PACK
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	GREEN/ORANGE (+) See NOTE *2	IN DRIVERS DOOR HARNESS, See DIAGRAM
ANTI-THEFT	CHRYSLER'S SENTRY KEY (GRAY KEY ONLY) A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 this vehicle uses a 1-Wire Door Locking System, the LOCK requires a (+)Positive thru a 620 Ohm Resistor and the UNLOCK requires a (+)Positive thru a 2700 Ohm Resistor, some units will also require 2 extra relays part #R30-H to connect, See DIAGRAM NOTE *2 the FACTORY DISARM wire requires a (+)Positive thrua 480 ohm Resistor and an extra relay part #R30-H to connect, See DIAGRAM