NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.
NOTE *2 WHEN INSTALLING A REMOTE STARTER TO THIS VEHICLE, AN EXTRA RELAY PART #775 IS NEEDED TO ISOLATE THE ACCESSORY WIRE, TO CONNECT, See DIAGRAM: 240SX NISSAN ACCESSORY ISOLATION CIRCUIT.
NOTE *3 THE ANTI-THEFT MODULE IS LOCATED JUST ABOVE HOOD RELEASE CABLE, IN THE DRIVERS KICK PANEL.
|