PART	COLOR	LOCATION
12 VOLT CONSTANT	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER	RED/LIGHT BLUE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	RED/LIGHT GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/LIGHT GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	GRAY/YELLOW (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT SWITCH or in DRIVERS KICK PANEL
POWER LOCK	PINK/YELLOW (5 Wire Reverse Polarity) See NOTE *1	IN EITHER KICK PANEL
POWER UNLOCK	PINK/LIGHT GREEN (5 Wire Reverse Polarity) See NOTE *1	IN EITHER KICK PANEL
DOOR TRIGGER	BLACK/LIGHT BLUE (+)	IN DRIVERS KICK PANEL
DOMELIGHT SUPERVISION	USE DOOR TRIGGER, Requires Part #R30-H Relay
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK BLUE (-)	@ STEERING COLUMN HARNESS
TACH	TAN/YELLOW	@ IGNITON COIL
WAIT TO START LIGHT	See NOTE *2
BRAKE	LIGHT GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	DARK GREEN/PURPLE (-)	IN DRIVERS DOOR HARNESS
ANTI-THEFT	N/A

EXTRA INFORMATION

NOTE *1 If equipped with FACTORY KEYLESS ENTRY, Vehicle is a TYPE "B" Door Locking System, WITHOUT FACTORY KEYLESS, This is a 5 Wire Reverse Polarity Door Locking System and you MUST get the lock and unlock wires in the PASSENGER KICK PANEL (Parking Brake Braket is in the way) you MUST also TEST for SWITCH and MOTOR wires ONLY with the DRIVERS DOOR SWITCH. On this 5 Wire Reverse Polarity System you MUST TEST from the DRIVERS DOOR Switch only when testing for SWITCH and MOTOR wires. NOTE *2 The DIESEL TACH wire is a WHITE/PINK and the WAIT TO START is a BLACK/PINK (-) both wires are located at the PCM (Powertrain Control Module) or at the MAIN HARNESS that runs on the inside of the firewall to the left of the brake pedal. The WAIT TO START wire MUST BE DIODE ISOLATED, to connect, See DIAGRAM.