PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	PURPLE (+) or YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ STEERING COLUMN HARNESS
POWER LOCK	LIGHT BLUE (Positive (+))	NEXT TO UNDER DASH LIGHT
POWER UNLOCK	WHITE (Positive (+))	NEXT TO UNDER DASH LIGHT
DOOR TRIGGER	See NOTE *1	IN KICK PANELS See DIAGRAM
DOMELIGHT SUPERVISION	LIGHT GREEN/BLACK (-) Requires #R30-H Relay	IN DRIVERS KICK PANEL
TRUNK RELEASE	BLACK (+) Requires #R30-H Relay	@ TRUNK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ STEERING COLUMN HARNESS
TACH	See NOTE *2	@ IGNITION COILS
WAIT TO START LIGHT	N/A
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	(2) WHITE wires in a ORANGE or BLACK heat shrink tube in Steering column harness	GM's VATS System @ Ignition Switch

EXTRA INFORMATION

SPECIAL NOTE!!!! If vehicle is equipped with PASSKEY/VATS, Ignition Key will have a little Chip on the Steel Shaft of the Key that can be seen. NOTE *1 this vehicle uses (4) DOOR TRIGGER wires use the LIGHT GREEN.BLACK (-) in the drivers kick panel for the Drivers door, use the LIGHT BLUE (-) in the passenger kick panel for the Passenger door. For the 2 rear doors us the pin switch wires at each door pin switch and diode isolate with a 6 amp diode use all 4 wires for an alarm. For Dome Light supervision use on the LIGHT GREEN.BLACK (-) in the drivers kick panel for the Drivers door. NOTE *2 on the 4-Cylinder use the WHITE or ORANGE wire, and on the V-6 use the PURPLE/WHITE