Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 1991-1997 Nissan Pick-Up . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
PART
COLOR
LOCATION
12 VOLT
CONSTANT
WHITE/BLACK (+)
IGNITION SWITCH HARNESS
STARTER
BLACK/YELLOW (+) See NOTE *1
IGNITION SWITCH HARNESS
STARTER
2
BLACK/YELLOW (+) See NOTE *1
IGNITION SWITCH HARNESS
IGNITION
1
BLACK/WHITE (+)
IGNITION SWITCH HARNESS
IGNITION
2
N/A
IGNITION
3
N/A
ACCESSORY/HEATER
BLOWER 1
BLACK/BLUE (+)
IGNITION SWITCH HARNESS
ACCESSORY/HEATER
BLOWER 2
N/A
KEYSENSE
N/A
PARKING
LIGHTS ( - )
N/A
PARKING
LIGHTS ( + )
PINK/BLUE (+)
@ STEERING COLUMN HARNESS
POWER LOCK
BLACK/YELLOW (TYPE B)
IN DRIVERS KICK PANEL
POWER UNLOCK
BLACK/RED (TYPE B)
IN DRIVERS KICK PANEL
DOOR TRIGGER
RED/BLACK (-)
LOCATED IN LEFT A PILLAR
DOMELIGHT
SUPERVISION
USE DOOR TRIGGER, Requires Part #775 Relay
TRUNK RELEASE
N/A
SLIDING
POWER DOOR
N/A
HORN
LIGHT GREEN/BLACK (-)
@ STEERING COLUMN HARNESS
TACH
WHITE
@ LARGE CONNECTOR, BY DRIVERS KICK PANEL
WAIT TO
START LIGHT
N/A
BRAKE
GREEN/YELLOW (+)
@ SWITCH ABOVE BRAKE PEDAL
FACTORY
ALARM DISARM
N/A
ANTI-THEFT
N/A
EXTRA
INFORMATION
NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.