PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+) or PURPLE (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	PINK (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	BROWN (+)	@ HEADLIGHT SWITCH or FUSEBOX
POWER LOCK	LIGHT BLUE (Positive (+))	IN DRIVERS DOOR HARNESS
POWER UNLOCK	BLACK/WHITE (Positive (+))	IN DRIVERS DOOR HARNESS
DOOR TRIGGER	WHITE (-)	@ UNDER DASH LIGHT
DOMELIGHT SUPERVISION	USE DOOR TRIGGER, Requires #R30-H Relay
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	BLACK (-)	@ STEERING COLUMN HARNESS
TACH	PURPLE/WHITE	@ DISTRIBUTOR or ECM, See NOTE *1
WAIT TO START LIGHT	DARK BLUE (+) See NOTE *2	@ INSTRUMENT CLUSTER
BRAKE	WHITE (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	N/A
ANTI-THEFT	N/A

EXTRA INFORMATION

NOTE *1 The ECM (Electronic Control Module) is located BEHIND the GLOVEBOX, it is a SILVER BOX with (2) plugs. NOTE *2 when hooking up a REMOTE STARTER on a DIESEL, if the WAIT to START wire from the Remote Starter does not wait until the Light on the dash turn out before cranking, you will need to program in the 5,10 or 15 Second WAIT to START TIMMER in the Installation Manual. On some vehicles the Wait to Start Light on the dash is not a true (+)Positive or (-)Negative and the wire from the Remote Starter will not owrk. When this Wait to Start Timmer is programmed, disconnect and tape up the Wait to Start wire from the Remote Starter that is tied into the Wait to Start Light on the dash.